Readers ask: 80 Hp Tractor Pulls What Size 252 Oliver Disc?

What size tractor do I need for a 10 foot disc?

You could easily handle a 10 ‘ wheel disc with 50-65 horse tractor.

How much horsepower does it take to pull a 14 foot disc?

It would take 100+ HP to pull a 14 foot IH 500 series in heavy soil.

How much horsepower does it take to pull a 24 foot disc?

Better to have too much than too little, right? Around here a 24 ‘ cutting disc in tough conditions would require a 4840, in normal conditions a 4640 would pull it.

How much horsepower does it take to pull a 10 disc?

A 30-40 hp would pull a 10 ft oneway in most conditions. A 30-40 hp could only pull a 3-4 disc plow.

How big of a disc can a 50 hp tractor pull?

You can pull a Tandem Disc Harrow with 22″ diameter pans seven to eight feet in width, bearing in mind cutting width is LESS than overall width. A Disc Harrow with 22″ diameter pans is usually heavy enough to cut sod with moist soil below without previous plowing.

You might be interested:  Often asked: How To Install Tractor Pto Drive Shaft?

How much horsepower does an offset disc need?

You need at least 10 drawbar horsepower per foot to make it shine, all the weight you can hang on the tractor and stay out of the WET HEAVY SOILS!!!! Find you a 225 or a 425 Deere offset with the cone blades, they will cover alot of trash. It won’t be as heavy as the same width Bush Hog.

How much horsepower does it take to pull a 20 foot disc?

Subject: RE: Typical Hp requirements for a 20 foot disk? 150 is plenty. 120 would even do it. In a pinch I’ve used my 7710 MFWD Ford to pull my 22ft 490 it was a load but it would pull it.

What does a disc harrow do?

A disc harrow is a harrow whose cutting edges are a row of concave metal discs, which may be scalloped, set at an oblique angle. It is an agricultural implement that is used to till the soil where crops are to be planted. It is also used to chop up unwanted weeds or crop remainders.

How much horsepower is needed to pull a chisel plow?

Horsepower requirement for chisel plows is 12 to 15 HP per shank.

How fast should you disc a field?

For example, operating a disc too fast or too slow prevents it from penetrating the soil at the correct depth. The disc won’t be able to effectively break up and toss the soil, which leads to shallow cuts. In most conditions, the optimal operating speed is approximately 4–6 miles per hour.

How much weight can a 40 hp tractor pull?

Your tractor lists at 4130 to 4566 pounds without FEL or added weight. I would hook it up and try it on level ground and see how it acts.

You might be interested:  Question: What Is The Best Used John Deerer Tractor?

How much HP does it take to pull a field cultivator?

Subject: RE: How much HP does it take to pull a field cultivator with baskets per foot? A standard rolling basket mounted or pull type takes one HP per foot.

Leave a Reply

Your email address will not be published. Required fields are marked *

Adblock
detector