What Size Implements Can A 160 Hp Tractor Pull?

How much horsepower do you need to pull a 12 row planter?

Tractors needed depend a lot on types of tillage operations (or lack thereof), fertilizer application, etc. To just pull a 12 row planter would require a tractor of about 120 hp (depending on attachments etc.) Pulling an ammonia toolbar in the fall could require more like 165 hp.

How much horsepower does it take to pull a 16 row planter?

Subject: Re: how much hp needed for a 16 row planter. A 150 hp tractor will handle the 16 row, but may need mfd for weight up front, when planter is in transport position.

How much horsepower does it take to pull an 8 row planter?

We pulled an 8 rn planter for years and years with a 70-75 HP 706 IH. You should be fine with any of your options. No issues on HP with any of them. If you feed on any hills, I would avoid feeding on narrows.

You might be interested:  Husqvarna Tractor Zero Turn Oil Change What Oil To Put?

How big of a disk can a 100 hp tractor pull?

For discing 4-5 inches deep your tractor should be able to handle a 14′ tandem disc very nicely. If you want to go deeper then you will need to go smaller.

How much horsepower does it take to pull a 4 row planter?

I can remember pulling a 4 row IH plate planter with an 8N Ford many long years ago, and it did not struggle. So your 40 hp should be able to do the job.

How much HP does it take to pull a planter?

Pulling a 24-row planter, “we need a 310- horsepower tractor at 7 to 7 1/2 mph. We couldn’t even go at 8 1/2 to 9 mph and pull it right,” McKinney says.

How much horsepower does it take to pull a 20 foot disc?

Subject: RE: Typical Hp requirements for a 20 foot disk? 150 is plenty. 120 would even do it. In a pinch I’ve used my 7710 MFWD Ford to pull my 22ft 490 it was a load but it would pull it.

How much horsepower does it take to pull a 24 foot disc?

Better to have too much than too little, right? Around here a 24 ‘ cutting disc in tough conditions would require a 4840, in normal conditions a 4640 would pull it.

How wide is a 12 row planter?

Call Us

Key Specs:
Dimensions:
Transport width (with markers) 3494 mm 137.56 in.
Transport length 9197 mm 362 in.
Transport height 3487 mm 137.3 in.

47 

How big of a disc can a 55 hp tractor pull?

How big of a disc can a 55 HP tractor pull with the 3pt? You could easily handle a 10′ wheel disc with 50-65 horse tractor.

You might be interested:  Often asked: How Hard Is It To Take A Bagger Of A Rider Tractor?

How much horsepower do you need to pull a chisel plow?

Horsepower requirement for chisel plows is 12 to 15 HP per shank.

How much horsepower do you need to pull an offset disc?

You need at least 10 drawbar horsepower per foot to make it shine, all the weight you can hang on the tractor and stay out of the WET HEAVY SOILS!!!! Find you a 225 or a 425 Deere offset with the cone blades, they will cover alot of trash. It won’t be as heavy as the same width Bush Hog.

Leave a Reply

Your email address will not be published. Required fields are marked *